|
|
ventilative sleeve pipe |
|
continues the sleeve pipe |
|
| Home → Product List → Wiring product:assembling ventilative sleeve pipe |
XF7-29 type assembling type ventilative sleeve pipe |
 |
| □ Characteristic: |
- Product this is it inflate aerial cable that type maintain to suitable for mainly.
- The empty shaping craft in the products are adopted, the appearance is beautiful , light and handy.
- It is convenient to install and maintain, it is opened that can be repeated, buckling , products, in order to buckle vertically.
- Form a complete set with the wiring son or the wiring module , can be used as the branch of the cable , select the cables of different specifications for use wantonly .
- Select suitable materials to pay attention to, defend ultraviolet radiation , the advantage such as being cold-resistant , ageing-resistant , waterproof , dampproof , ventilative.
|
| □ Main technical indicator: |
- Environment temperature: -30 - +60 degrees Centigrade of environmental atmosphere pressure 86-106KPa.
- Buckle and test: Circulation behind the 200, hinge office is it whiten sign of fracturing to have, the snap link has no phenomenon of coming off.
- Temperature circulation: Low temperature- 30- ± 2 degrees Centigrade of high-temperature +60± 2 degrees Centigrade is during the course of changing urgently in temperature, it is not smaller than 4h to stay. No Unusual phenomenon of rupturing etc..
- Axial pulling force, with d/45X100N axial pulling force, cable draw taking off after lasting 2h test.
|
| □ Working technique : |
- Open the spring first, take down the sealed circles of two ends of sleeve pipe .
- According to the specification of the cable, measure the diameter of the cable with the circumference scale , then according to sealing and circling the letters marked from cutting off positively with the small scissors, in the middle of left partly (see Fig. 1)
- Cross and seal and enclose the main cable and branch cable from side to side separately, confirm the length of interface of the cable in the sleeve pipe . L, 10-50 pairs =242mm,
10-150 pairs =356mm, 200-400 pairs --493mm,400-600 --533mm, carries on butt joint. (see Fig. 2)
- Meet with the cable shielding thread of Model Y and ground wire of both ends of cable.
- Fetch two plastics and pitch and take the regular cable.
- Seal two and enclose installing it in two ends of sleeve pipe, buckle the good sleeve pipe .
|
|
| □ Guide to the order |
|
|
